walkera dragonfly 36 rc helicopter

Discussion in 'Walkera Helicopters' started by Junior Ellis, Jul 12, 2021.

  1. Junior Ellis
    Offline

    Junior Ellis Member

    Top Poster Of Month

    Joined:
    Sep 22, 2018
    Messages:
    112
    Likes Received:
    10
    Trophy Points:
    18
    Location:
    Newcastle NSW
    Ratings:
    +12 / 0
    Hi guys i have another Walkera heli but i want to use my devo 10 BJ can you help bro :) and Bj can you add me on Facebook if possible.

     
  2. bjr981s
    Offline

    bjr981s Moderator Staff Member

    Joined:
    Sep 19, 2015
    Messages:
    6,250
    Likes Received:
    451
    Trophy Points:
    83
    Location:
    Sydney, Australia
    Ratings:
    +577 / 16
    Here is a vid of another Dragonfly. Assume yours is the same.



    Also assume it's Flybarred as well

    The RX on these was pre Devention. You would need Deviation installed on your 10 to bind.

    Best choice is to just swap the RX. The Gyro should be fine if it's still OK.

    You will need either: PWM RX.

    24.82US $ |Walkera RX701 2.4Ghz 7ch Receiver RX 701 For Walkera Devo 6 7 8s 12s F7 Transmitter RC Helicopter Aircraft FS|Parts & Accessories| - AliExpress

    Or PPM/Sbus with a PPM / Sbus to PWM converter.

    JHEMCU SPP 8CH Signal Converter Module Support SBUS PPM PWM Output for Receiver

    Walkera RX-SBUS 2.4G 12CH Receiver SBUS PPM Output For Devo 7 F7 F10 F12E

    Got your Facebook Request. Did the search came back with a zillion matches. Need more info to friend.
     
  3. Junior Ellis
    Offline

    Junior Ellis Member

    Top Poster Of Month

    Joined:
    Sep 22, 2018
    Messages:
    112
    Likes Received:
    10
    Trophy Points:
    18
    Location:
    Newcastle NSW
    Ratings:
    +12 / 0
    Yeah i have a devo 10 receiver already and thinking of swapping yes i think Gyro should be fine,im just dont know what setting i may need to installed on the devo 10 radio :)
     
  4. bjr981s
    Offline

    bjr981s Moderator Staff Member

    Joined:
    Sep 19, 2015
    Messages:
    6,250
    Likes Received:
    451
    Trophy Points:
    83
    Location:
    Sydney, Australia
    Ratings:
    +577 / 16
    Should be simple. Give me a picture of the swash / Servo layout from above. Should be almost the same as the V450D03

    Pitch will be on Channel 6. Gyro on 5 and the others normal. Just need to get the swash layout programmed.
    Gyro sensitivity will control the tail heading lock.
     

Share This Page