Walkera QR Y100 Drone won't hover.

I am running the WK iremote on my Nexus 10 tablet. I calibrate the compass and return to the control screen. When I press the auto launch icon, the drone lifts off and instead of hovering it takes off in random directions and I have to land to shut it down. Home does not work. Is there a way to calibrate the drone to hover when the controls are released? HELP!

 

I just got mine and having the same problem.

 

Have a look at this YouTube: watch out for the 5:19 mark where the demonstrator changes to flight mode 2. I followed his setup method and used flight mode 2 as he suggests and I noticed an immediate improvement.

However ther is one step he left out and it's important. In the Set-Up mode there are two "compass" calibrations, one for the horizontal and vertical rotation and the other labelled Compass Calibration", this one involves moving the 'copter in a figure eight motion twice, horizontally (on the table top) and vertically (on a door face). I did this and I had a successful flight albeit a bit rough.

The "Mode" switch is the very top one, change it to 2.

Regards