Stick not responding to motors (Devo7/RX-SBUSE/SPF3/BetaFlight)

Discussion in 'Walkera Devention Radios' started by mur2, Oct 17, 2017.

  1. mur2
    Offline

    mur2 New Member

    Joined:
    Oct 17, 2017
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    1
    Ratings:
    +0 / 0
    I am using Devo 7 TX paired w/ the new RX-Sbuse and using Seriously Pro F3 Flight Controller. TX and RX bonding was fine, RX is connected to UART 3 on my FC, already selected Serial RX on UART 3 in BetaFlight. In betaflight under Receiver tab, they respond to my stick movements, but the motor is not moving. Is there any setup I need to do on my Devo 7? no problem w/ motors or escs as I can spin the motors using betaflight. And also I am able to setup the mode(arm) as betaflight detects my switch. Please Help! it's been 3 days having this issue :(

     
  2. bjr981s
    Offline

    bjr981s Moderator Staff Member

    Top Poster Of Month

    Joined:
    Sep 19, 2015
    Messages:
    5,367
    Likes Received:
    353
    Trophy Points:
    83
    Location:
    Sydney, Australia
    Ratings:
    +455 / 14
    Remember that the Walkera Devo radios outputs EATR not Futaba standard AETR
     

Share This Page

Search tags for this page

devo 7 rx wont connect to betaflight

,

walkera sbus motor spin