Starting problems

Discussion in 'Walkera Runner 250 Pro' started by foxcat, May 9, 2018.

  1. foxcat
    Offline

    foxcat New Member

    Joined:
    May 9, 2018
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    1
    Ratings:
    +0 / 0
    Dears

    I need your expertise.

    A Walkera Runner 250 PRO (last model) just bought from Amazon IT, perfect service!

    That are the problems.

    - followed the usual steps in unboxing and charging the battery. Fine!

    - Model on a flat stable table, no propellers

    - Switched on the Radio, left stick full down (Mode 2) waiting the initialisation, connected the buttery to 250PRO, …binding. Radio display shows Trust 0%.

    - Left stick full leftdown, unlock the motor…..the motors start to run !!!!

    - If I do not touch anything after few seconds (let say 3-5) the system lock again

    - If I keep the trust stick at level of 15-20% or above, the system remain locked

    Is there any help

    Thanks

    Marco

     
  2. bjr981s
    Offline

    bjr981s Moderator Staff Member

    Top Poster Of Month

    Joined:
    Sep 19, 2015
    Messages:
    5,263
    Likes Received:
    328
    Trophy Points:
    83
    Location:
    Sydney, Australia
    Ratings:
    +428 / 13
    That is the normal operation. You only have a few second to takeoff after you activate the motors. If you dont takeoff it figures you are not going to fly so it shuts them down for safety.

    Cheers
     

Share This Page