SOLVED: After Devo7 Reset and Cleanflight flash dont arm

Discussion in 'Walkera Rodeo 150' started by de4dc3ll, Jan 7, 2019.

  1. de4dc3ll
    Offline

    de4dc3ll New Member

    Joined:
    Jan 7, 2019
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    1
    Ratings:
    +0 / 0
    Hello,

    the R150 just does not want to be arm. As soon as I plug in a Lipo and turning Devo on, it beeps normally, and after 3 beeping, only the LED flashes slowly.
    She recognizes the DEVO7 - by the fact that I put the beeper on a switch, which goes also.

    In Cleanflight, the Devo is also fully recognized. But if I put ARM on a switch and press it, the R150 beeps 5x very fast, 1x slow, 2x fast. what does this mean?

    I can adjust motors in the Cleanflight - theyre working fine.

    Lipos all full. Had unfortunately despair in the DEVO reset everything.
    Mode 2 is set.

    Help - i need somebody - help!

     
  2. de4dc3ll
    Offline

    de4dc3ll New Member

    Joined:
    Jan 7, 2019
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    1
    Ratings:
    +0 / 0
    SOLUTION: USE USB PORT 2.0 ... had previously used USB 3.0, so flashing over Cleanflight 1.2 has always failed. I flashed the original FW of Walkera Rodeo 150 (Resources Section)

    Then the Devo could connect again normally.
     

Share This Page