Runner 250 pro motors spin and stop

Discussion in 'Walkera Runner 250 Pro' started by l1nshi, May 29, 2020.

  1. l1nshi
    Offline

    l1nshi New Member

    Joined:
    May 28, 2020
    Messages:
    9
    Likes Received:
    0
    Trophy Points:
    1
    Ratings:
    +0 / 0
    Turn on controller, plug in battery, binding is success, unluck motors, they start spinning at about 50% and after like 8 seconds stop. I am using Devo 7, I think the problem is with controller's settings.

     
  2. bjr981s
    Offline

    bjr981s Moderator Staff Member

    Top Poster Of Month

    Joined:
    Sep 19, 2015
    Messages:
    5,978
    Likes Received:
    441
    Trophy Points:
    83
    Location:
    Sydney, Australia
    Ratings:
    +566 / 16
    That is normal behaviour on the pro. If you don't take off within that 8 seconds it stops the motors.
     

Share This Page