Rodeo 150 not beper

Discussion in 'Walkera Rodeo 150' started by Barabba, Jun 27, 2019.

Tags:
  1. Barabba
    Offline

    Barabba New Member

    Joined:
    May 13, 2019
    Messages:
    16
    Likes Received:
    1
    Trophy Points:
    3
    Ratings:
    +1 / 0
    hello guys my 150 when I connect the battery emits the typical sound of the ignition then the red light continues to flash but the beper does not sound, after I bind the radio, if active the beper switch the light flashes but no sound, even if the battery lowers flashes but does not sound ... what can have happened

     
  2. bjr981s
    Offline

    bjr981s Moderator Staff Member

    Top Poster Of Month

    Joined:
    Sep 19, 2015
    Messages:
    5,757
    Likes Received:
    429
    Trophy Points:
    83
    Location:
    Sydney, Australia
    Ratings:
    +542 / 15
    Did you connect it to your PC? Did you use Cleanflight to adjust anything?
     
  3. Barabba
    Offline

    Barabba New Member

    Joined:
    May 13, 2019
    Messages:
    16
    Likes Received:
    1
    Trophy Points:
    3
    Ratings:
    +1 / 0
    yes i connected it to pc and modified pid. and and radio switches including the biper one I connected several times and it worked ... I didn't realize if it stopped working before I have after a fall
     
  4. bjr981s
    Offline

    bjr981s Moderator Staff Member

    Top Poster Of Month

    Joined:
    Sep 19, 2015
    Messages:
    5,757
    Likes Received:
    429
    Trophy Points:
    83
    Location:
    Sydney, Australia
    Ratings:
    +542 / 15
    That is a risk as advised earlier. IT connected several times but did you actually fly it?

    If you crashed it then you need to pull apart and check all the wiring. Particularly the RX and Flight controller. The connections get jarred loose.

    Cheers Brian
     
  5. Barabba
    Offline

    Barabba New Member

    Joined:
    May 13, 2019
    Messages:
    16
    Likes Received:
    1
    Trophy Points:
    3
    Ratings:
    +1 / 0
    Hi Brian I am Marcello .. I flew there and it worked perfectly until the last time I crashed I opened and checked and it seems all ok the strange thing is that activating the switch the LED is activated but the beeper no beeper only plays when I insert the battery you have advice
     
    Last edited: Jun 29, 2019
  6. bjr981s
    Offline

    bjr981s Moderator Staff Member

    Top Poster Of Month

    Joined:
    Sep 19, 2015
    Messages:
    5,757
    Likes Received:
    429
    Trophy Points:
    83
    Location:
    Sydney, Australia
    Ratings:
    +542 / 15
    You need to remove the RX and the FC.

    Check and clean the connectors.
     

Share This Page