Resetting the FC and BT controller

Discussion in 'Walkera Scout X4' started by chase, May 4, 2016.

  1. chase
    Offline

    chase Member

    Joined:
    Mar 12, 2016
    Messages:
    150
    Likes Received:
    5
    Trophy Points:
    18
    Location:
    Planet Earth
    Ratings:
    +6 / 0
    I know you can reset the FC Fixed ID.

    Will that reset the entire FC? I mean wipe it clean for a reinstall of the firmware?

    Can the same be done to the BT units?

    I'm hoping that if it does wipe it clean, blank slate it. Reinstalling firmware will clear up issues.

    Enable completing binding between the GCS.

    Thanks

     
  2. bjr981s
    Offline

    bjr981s Moderator Staff Member

    Top Poster Of Month

    Joined:
    Sep 19, 2015
    Messages:
    5,263
    Likes Received:
    328
    Trophy Points:
    83
    Location:
    Sydney, Australia
    Ratings:
    +428 / 13
    You have to connect I bind plug the the battery input and move the battery to another port on the FC.

    I posted this in detail in another thread. I should find it and cut and post as a sticky.
     
  3. chase
    Offline

    chase Member

    Joined:
    Mar 12, 2016
    Messages:
    150
    Likes Received:
    5
    Trophy Points:
    18
    Location:
    Planet Earth
    Ratings:
    +6 / 0
    Again you've miss read or miss understood the question.
     
  4. bjr981s
    Offline

    bjr981s Moderator Staff Member

    Top Poster Of Month

    Joined:
    Sep 19, 2015
    Messages:
    5,263
    Likes Received:
    328
    Trophy Points:
    83
    Location:
    Sydney, Australia
    Ratings:
    +428 / 13
    Only god and the original designer can answer that question.

    I have not seen a procedure anywhere.
     

Share This Page