PWM connections between Walker RX610 receiver and Naze32 Flight Controller

Discussion in 'Walkera Devention Radios' started by MoyRC, Sep 14, 2016.

  1. MoyRC
    Offline

    MoyRC New Member

    Joined:
    Sep 13, 2016
    Messages:
    8
    Likes Received:
    0
    Trophy Points:
    1
    Ratings:
    +0 / 0
    Hi guys,

    First time building a quadcopter, so I’m super excited! I just purchased the Walkera Devo 7 transmitter which has the RX601 six channel receiver for my builds.

    The RX601 receiver does not have listed channels 1 through 6, but instead has the following listed: ELEV, AILE, THRO, RUDD & GEAR.

    I’m trying to connect my Naze32 Ver 6 6DOF Flight Controller to my RX601 receiver, but I’m not sure in what order to connect the leads. The Walkera RX601 receiver is Not PPM, have to connect via PWM method. Not sure where pin 1 through 8 on the Naze32 flight controller correspond to the ELEV, AILE, THRO, RUDD & GEAR connetions on my Walkera RX601 receiver.

    Can someone help me? What order do I connect the leads between the Naze32 Ver 6 6DOF Flight Controller and my Walkera RX601 receiver?


    Appreciate all and any help!
     
  2. bjr981s
    Offline

    bjr981s Moderator Staff Member

    Top Poster Of Month

    Joined:
    Sep 19, 2015
    Messages:
    3,923
    Likes Received:
    238
    Trophy Points:
    63
    Location:
    Sydney, Australia
    Ratings:
    +313 / 10
    The channels on the RX601 are Futaba standard. (AETR)

    So from Channels 1 to 6 is:

    1. Aileron
    2. elevator
    3. throttle
    4. rudder
    5. gear (Aux1)
    6. flap (Aux2)
    The Aux1 and Aux2 is what the FC normally label these channels.

    Cheers
     

Share This Page

Search tags for this page

connections for devo 6 with rx601 receiver