"Not Support" showing on osd in goggle2

Discussion in 'Walkera Runner 250' started by Mevsmyself, Jun 22, 2018.

  1. Mevsmyself
    Offline

    Mevsmyself New Member

    Joined:
    Jun 22, 2018
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    1
    Ratings:
    +0 / 0
    Hi I just bought a runner 250. Not sure what model (i bought it used) , I think it may be the advanced model. It has gps and seems to have devo 7 10.2 remote. When i plug in my goggle2 fpv goggles the osd shows "not support".
    What does this mean? The message is dead center and has a hazzard symbol above it.
    Please help!! Also when I unlock the motors the left rear led still flashes is this normal?
    Thanks in advance :)

     
  2. bjr981s
    Offline

    bjr981s Moderator Staff Member

    Top Poster Of Month

    Joined:
    Sep 19, 2015
    Messages:
    5,320
    Likes Received:
    335
    Trophy Points:
    83
    Location:
    Sydney, Australia
    Ratings:
    +437 / 14
    It means that the trim is not all centred to 0 and you have some left aileron or rudder trim.

    Dont have a set, if it supports SD cards does it have a faulty SD card inserted?
     

Share This Page