New with a QRx350 and have an issue

Discussion in 'Introductions and Site Help' started by MPression, Apr 27, 2021.

Tags:
  1. MPression
    Offline

    MPression New Member

    Joined:
    Apr 27, 2021
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    1
    Ratings:
    +0 / 0
    Hi there,

    I have had a few little quad copters, but bought a 2nd hand QR X350 pro.

    I do photography so wanted to upgrade to a larger quad for this purpose.

    However I do have an issue with it... the reason the seller sold it, he said he hooked it up to some software. and the point of view changed.

    So I have tried googling the issue but cant find anything.

    so when you pugh control forward it goes forward, how ever if you spin it -90,90 or 180 degrees, and push forward, instead of it going forward from the point of view of the copter, it stays going forward from the point of view of where I am the controller,

    Is there a way to fix this, so it goes from copter point of view?

     
  2. bjr981s
    Offline

    bjr981s Moderator Staff Member

    Top Poster Of Month

    Joined:
    Sep 19, 2015
    Messages:
    6,259
    Likes Received:
    452
    Trophy Points:
    83
    Location:
    Sydney, Australia
    Ratings:
    +578 / 16
    Yes, it is in a special flight mode. (Heading Hold) I guess he did something with the Transmitter programming. It is normally activated by a switch.

    What is then TX I will direct you how to fix.

    Cheers
     
  3. MPression
    Offline

    MPression New Member

    Joined:
    Apr 27, 2021
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    1
    Ratings:
    +0 / 0
    Thanks,
    and it is the Devo F7
     
  4. bjr981s
    Offline

    bjr981s Moderator Staff Member

    Top Poster Of Month

    Joined:
    Sep 19, 2015
    Messages:
    6,259
    Likes Received:
    452
    Trophy Points:
    83
    Location:
    Sydney, Australia
    Ratings:
    +578 / 16
    OK the F7 will be an issue. You will need the quick start guide for the drone. It will have instructions for programming the radio but it won't be an F7.

    All the programming is basically the same on all Walkera radios you will just need to adapt for the F7.

    It is likely that this config file will work load it to a spare model memory on the radio.



    Cheers
     

    Attached Files:

Share This Page