Master cp

Discussion in 'Walkera Helicopters' started by Stalk2015, Jun 19, 2017.

  1. Stalk2015
    Offline

    Stalk2015 New Member

    Joined:
    Feb 26, 2017
    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    1
    Ratings:
    +0 / 0
    i have issues with servos ,they work fine until you start to throttle up then they start to twitch and go all directions on there own but only with throttle . I have changed receiver no difference and new servos same situation any suggestions?
     
  2. bjr981s
    Offline

    bjr981s Moderator Staff Member

    Top Poster Of Month

    Joined:
    Sep 19, 2015
    Messages:
    4,021
    Likes Received:
    241
    Trophy Points:
    63
    Location:
    Sydney, Australia
    Ratings:
    +318 / 10
  3. Stalk2015
    Offline

    Stalk2015 New Member

    Joined:
    Feb 26, 2017
    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    1
    Ratings:
    +0 / 0
    I have upgraded the servos to metal , still no change ,the servos work fine till you throttle up then they start to twitch and extend all the way without full command ,I thought it was the reciever and changed it same thing happens ,you can fly it but it is tough ,I have two v450do3 's they fly perfectly ,I tried to fly the master cp on there program same thing
     
  4. bjr981s
    Offline

    bjr981s Moderator Staff Member

    Top Poster Of Month

    Joined:
    Sep 19, 2015
    Messages:
    4,021
    Likes Received:
    241
    Trophy Points:
    63
    Location:
    Sydney, Australia
    Ratings:
    +318 / 10
    Did you buy the OEM Metal gear servos?

    Have you got the servos connected to the correct channels?

    Can you make a video of the swash plate movement and advise what controls you are using while doing it. Elevator Aileron and Throttle / Pitch. Unplug the motor for this.

    Cheers
     

Share This Page