How do I control my ilook + from my Devo 10 radio. I have a Tali with some conversations'

Discussion in 'Walkera Devention Radios' started by Andy Fisher, Feb 5, 2019.

  1. Andy Fisher
    Offline

    Andy Fisher New Member

    Joined:
    Feb 5, 2019
    Messages:
    4
    Likes Received:
    0
    Trophy Points:
    1
    Ratings:
    +0 / 0
    How do I control my ilook + from my Devo 10. It's on a Tali with some conversation but the receiver is original. Thanks

     
  2. bjr981s
    Offline

    bjr981s Moderator Staff Member

    Top Poster Of Month

    Joined:
    Sep 19, 2015
    Messages:
    5,462
    Likes Received:
    372
    Trophy Points:
    83
    Location:
    Sydney, Australia
    Ratings:
    +474 / 14
    You need to connect the Gimbal to the RX in the Tali and you need to activate the channels to control from the knobs. They are not active by default.
     
  3. Andy Fisher
    Offline

    Andy Fisher New Member

    Joined:
    Feb 5, 2019
    Messages:
    4
    Likes Received:
    0
    Trophy Points:
    1
    Ratings:
    +0 / 0
    Would that be the 2 round knobs on top.
     
  4. Andy Fisher
    Offline

    Andy Fisher New Member

    Joined:
    Feb 5, 2019
    Messages:
    4
    Likes Received:
    0
    Trophy Points:
    1
    Ratings:
    +0 / 0
    I thought I would have my first flight with the Tali today. Weather has improved. Anyway, switched on transmitter (TX for short, is that right) and then quickly followef by battery on. With all the bleeps and flashes and the short motor run it seemed a success . Landing gear folded. My camera vertical axis adjusted on the top right rotating channel but I had no response with motors on left hand stick. Anybody have any ideas as to why.
     

Share This Page