Hi, new to drones and the forum looking for some advice

Discussion in 'Walkera Help!' started by maglike, Mar 26, 2015.

  1. maglike
    Offline

    maglike New Member

    Joined:
    Mar 26, 2015
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    1
    Ratings:
    +0 / 0
    I recently won a Walkera Tali H500 Drone and have assembled it, but haven't attempted to fly it. I viewed the info on the DVD and wanted to print the manual. The manual is divided into multi sections. First, a description of the TX then it identifies setup for a Helicopter, then Airplane and lastly a Glider. My question is, which setup should I refer to? Also, is there an unused channel on the RX that could be tasked with operating a small winch that could be used for RC boat recovery mainly to tow the disabled craft back to shore. Thanks for taking the time to read this post and perhaps offer some advice.
     
  2. tomross2002
    Offline

    tomross2002 Member

    Joined:
    Mar 1, 2015
    Messages:
    53
    Likes Received:
    1
    Trophy Points:
    6
    Ratings:
    +1 / 2
    Hi, it's an airplane for some reason. I do know that. As far as an unused channel I'm not sure. If you use the ENT button on the devo it will take you to 3 menus. ..Hit ENT again toenter the FUNCTION menu. Scroll down to TRAVEL ADJUST and enter that menu. ..there you will find all the values for each switch. ..the legs are AUX 4 for example.
     

Share This Page