Help tali500 inibhit 2.4 e 5.8

Discussion in 'Walkera TALI H500' started by Celestino, May 26, 2019.

  1. Celestino
    Offline

    Celestino New Member

    Joined:
    May 26, 2019
    Messages:
    8
    Likes Received:
    0
    Trophy Points:
    1
    Ratings:
    +0 / 0


     
  2. Celestino
    Offline

    Celestino New Member

    Joined:
    May 26, 2019
    Messages:
    8
    Likes Received:
    0
    Trophy Points:
    1
    Ratings:
    +0 / 0
    Thank bir981s..
     
  3. bjr981s
    Offline

    bjr981s Moderator Staff Member

    Top Poster Of Month

    Joined:
    Sep 19, 2015
    Messages:
    5,610
    Likes Received:
    401
    Trophy Points:
    83
    Location:
    Sydney, Australia
    Ratings:
    +514 / 15
    OK,

    Looking at that Video I can make the following observations.

    The 2.4 signal is fine as it shows the GPS coordinates without any issues. No loss of Coordinate data. The Telemetry is a backchannel on the 2.4Ghz band.
    The 5.8 Ghz Video signal has some snow. This can be caused by one of the following.

    1. The transmitter is too close to the drone. You need to be about 5 metres away from the drone to allow the RX antenna and TX antenna to do their jobs correctly.
    2. The TX is on an adjacent receive channel to the drone. Make sure that the TX and RX are on the same Band B channel. Review the Quick Start Guide.
    3. Interference on the 5.8 Ghz band. The 5.8Ghz video signal is an analogue signal and subject to snow if another 5.8 Ghz signal is present. If you have Dual band WiFi in your house it will interfere with the video signal and cause snow. Test it again in open field where you would normally fly.
    Can you update your location in your profile. There are signal strength differences based on your country. EU has lower signal strength on 2.4 and 5.8 bands.

    Cheers Brian

     
Similar Threads
  1. Mark B
    Replies:
    10
    Views:
    2,241
Loading...

Share This Page