Help runner 250

Discussion in 'Walkera Runner 250' started by Reynaldo, May 4, 2018.

  1. Reynaldo
    Offline

    Reynaldo New Member

    Joined:
    May 4, 2018
    Messages:
    2
    Likes Received:
    0
    Trophy Points:
    1
    Ratings:
    +0 / 0
    I pair my new runner 250 With a new Devo 7E transmitter but do anything.
    I connect the drone to multiwii and the transmitter moves the pameters but drone wont turn motors.
    what should i do?
    Buy a orange rx r610v2 transmitter using cables or theres another way?

     
  2. OptimaZe
    Offline

    OptimaZe Member

    Joined:
    Jan 28, 2017
    Messages:
    32
    Likes Received:
    3
    Trophy Points:
    8
    Location:
    Goodrich MI
    Ratings:
    +4 / 0
    Are you following the procedure for arming the motors? If so, do the lights indicate that the quad has actually armed?
     
  3. bjr981s
    Offline

    bjr981s Moderator Staff Member

    Top Poster Of Month

    Joined:
    Sep 19, 2015
    Messages:
    5,204
    Likes Received:
    318
    Trophy Points:
    83
    Location:
    Sydney, Australia
    Ratings:
    +415 / 13
    Did you program the Devo 7? It will not work correctly if the model setup has not been configured on the radio and the trims and at 0 and the calibration completed on the TX. It is in the quick start guide.

    Dont connect to Multiwii you are likely to brick the Flight controller.
     

Share This Page