HELP PLEASE: BINDING ISSUE

Discussion in 'Walkera Devention Radios' started by rc.freakazoid, Sep 7, 2017.

  1. rc.freakazoid
    Offline

    rc.freakazoid New Member

    Joined:
    Sep 1, 2017
    Messages:
    16
    Likes Received:
    0
    Trophy Points:
    1
    Location:
    Arkansas, U.S.A
    Ratings:
    +0 / 0
    HAVE A NEW 1202 RX. I am trying to bind with my Devo F12E, i've read the little sticky on the forum and followed it to the T with no luck. I've tried following the manual with no luck, I've seen youtube videos and tried it different ways and everything I've tried the RX & TX never find each other??? Dont have a clue what to do next? only thing I did was unlock it updated to 1.5A when I got it, it was a RTF package radio



     
  2. rc.freakazoid
    Offline

    rc.freakazoid New Member

    Joined:
    Sep 1, 2017
    Messages:
    16
    Likes Received:
    0
    Trophy Points:
    1
    Location:
    Arkansas, U.S.A
    Ratings:
    +0 / 0
    Well after lots of cursing and pulling my hair out I finally got it to bind. Walkera has to be different dont they, as you know most all radio brands top pin is signal, middle pin is positive , and bottom is ground. After I figured out I was plugging the battery in wrong when I was trying to clear the id and bind the receiver all went smoothly!!!
     

Share This Page