G3D calibration issue

Discussion in 'Walkera QRX350/QRX 350 Pro/QRX 350 Premium' started by wasistdas, Feb 11, 2019.

  1. wasistdas
    Offline

    wasistdas Member

    Joined:
    Aug 4, 2017
    Messages:
    68
    Likes Received:
    2
    Trophy Points:
    8
    Location:
    Kiev, Ukraine
    Ratings:
    +2 / 0
    To calibrate G3D is a big problem. I have not found any normal instruction how to calibrate is right way. For example, I cannot make it keep right direction straight.

    Any idea?



     
  2. bjr981s
    Online

    bjr981s Moderator Staff Member

    Top Poster Of Month

    Joined:
    Sep 19, 2015
    Messages:
    5,669
    Likes Received:
    416
    Trophy Points:
    83
    Location:
    Sydney, Australia
    Ratings:
    +529 / 15
    Use the transmitter and adjust the centre trim.
     
  3. wasistdas
    Offline

    wasistdas Member

    Joined:
    Aug 4, 2017
    Messages:
    68
    Likes Received:
    2
    Trophy Points:
    8
    Location:
    Kiev, Ukraine
    Ratings:
    +2 / 0
    Where I can find pan adjustment there?
     
  4. bjr981s
    Online

    bjr981s Moderator Staff Member

    Top Poster Of Month

    Joined:
    Sep 19, 2015
    Messages:
    5,669
    Likes Received:
    416
    Trophy Points:
    83
    Location:
    Sydney, Australia
    Ratings:
    +529 / 15
    What knobs have you used to control the gimbal on your radio?

    Can you tilt the gimbal?
     
  5. wasistdas
    Offline

    wasistdas Member

    Joined:
    Aug 4, 2017
    Messages:
    68
    Likes Received:
    2
    Trophy Points:
    8
    Location:
    Kiev, Ukraine
    Ratings:
    +2 / 0
    Tilt and Roll are OK to tune while I cannot find a pan regulation
     
  6. bjr981s
    Online

    bjr981s Moderator Staff Member

    Top Poster Of Month

    Joined:
    Sep 19, 2015
    Messages:
    5,669
    Likes Received:
    416
    Trophy Points:
    83
    Location:
    Sydney, Australia
    Ratings:
    +529 / 15
    Did you buy the Gimbal with the Premium or did you buy it after? Can you show what wiring you have done from the Gimbal to the drone? and from the Gimbal controller.
     

Share This Page