g-2d gimbal roll motor assembly

Discussion in 'Walkera Help!' started by northdale, Jun 6, 2016.

  1. northdale
    Offline

    northdale New Member

    Joined:
    Jun 6, 2016
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    1
    Ratings:
    +0 / 0
    Hi. one of the solder joints broke on the roll motor. I was able to open it up and and fix that (I hope) but when I try to put the roll motor back together I have some problems. It seams like it should be so simple, but apparently I lack the IQ :p

    EDIT: Solved. I just had to force it in place.

    P1130416.jpg P1130417.jpg P1130418.jpg
    It looks like the end of the motor shaft is supposed to be inside of that "thing" but that's not possible.
    P1130419.jpg

     
    Last edited: Jun 7, 2016

Share This Page