Furious 320 gps motors dont arming.

Discussion in 'Walkera Help!' started by Antonio Neto, Nov 12, 2019.

  1. Antonio Neto
    Offline

    Antonio Neto Member

    Joined:
    Sep 19, 2016
    Messages:
    67
    Likes Received:
    1
    Trophy Points:
    6
    Ratings:
    +1 / 0
    I DONT HAVE any error.
    Regarding changes of raw parameters I don't agre with you, you can active Fence, you can change value of volts for protection of battery, you can change a parameter value in view to hit internal voltmeter,etcetc

     
  2. Antonio Neto
    Offline

    Antonio Neto Member

    Joined:
    Sep 19, 2016
    Messages:
    67
    Likes Received:
    1
    Trophy Points:
    6
    Ratings:
    +1 / 0

    NOTE THAT, MY CONCLUSION ABOUT THIS SUBJECT
    -The motores don't arm each time you made changes IN ROW PARAMETERS and save, file is corrupt.
    IT MEANS OR IS A SW BUG IN THE FLYCONFIG. OR A BAD MANAGEMENT. Due this fact the complete instructions of FC will be necessary. I KNOW ONLY INSTRUCTIONS FOR FW UPGRADE.
     
  3. bjr981s
    Offline

    bjr981s Moderator Staff Member

    Top Poster Of Month

    Joined:
    Sep 19, 2015
    Messages:
    6,032
    Likes Received:
    442
    Trophy Points:
    83
    Location:
    Sydney, Australia
    Ratings:
    +567 / 16
    Ok. But Walkera do not support changing these parameters it is not recommended and will have uncertain results.
     
  4. Junior Ellis
    Offline

    Junior Ellis Member

    Joined:
    Sep 22, 2018
    Messages:
    104
    Likes Received:
    9
    Trophy Points:
    18
    Location:
    Newcastle NSW
    Ratings:
    +11 / 0
    i use walkera flyconfig to re tune my pids been doing it ever since i got this drone,i have no issues at all drone respond nicely and i can see the changes :)
     

Share This Page