Furious 320 - Acro

Discussion in 'Walkera Furious 320' started by sn8keyz, Jun 20, 2017.

  1. sn8keyz
    Offline

    sn8keyz New Member

    Joined:
    May 24, 2017
    Messages:
    10
    Likes Received:
    0
    Trophy Points:
    1
    Ratings:
    +0 / 0
    Hello all,

    I read around the forum and have seen that the Furious 320 G cannot
    be programmed for any type of Acro mode - flips, rolls, etc.

    However, when I connected with FlyConfig (thank you Brian for your help),
    I see in the Raw Params settings 5 PID's that deal with ACRO.

    1. Acro_bal_pitch - Set to 1 (Options 0 or 3)
    2. Acro_bal_roll - Set to 1 (Options 0 or 3)
    3. Acro_rp_p - Set to 4.5 (Options 1 - 10)
    4. Acro_trainer - Set to 2 (0, 1, or 2)
    5. Acro_yaw_p - Set to 4.5 ( 1 - 10)

    There are also the FLTMODE's (1 - 6)

    1 - 3 are set to 0.
    4 - 6 are set to 5, 5, and 6...

    Is there anyway to program my furious 320(G) without changing parts
    to perform rolls and flips?

    I will take full responsibility if I break my machine.

    PR

     
  2. Nemo152
    Offline

    Nemo152 New Member

    Joined:
    Sep 28, 2016
    Messages:
    29
    Likes Received:
    1
    Trophy Points:
    3
    Ratings:
    +1 / 0
    Try itself. You will be the first. Then you will tell.
    Ofitsiala speak it is impossible, the compass will go crazy
     
  3. Adam from Warsaw
    Offline

    Adam from Warsaw New Member

    Joined:
    Apr 28, 2017
    Messages:
    22
    Likes Received:
    1
    Trophy Points:
    3
    Location:
    Warsaw Poland
    Ratings:
    +1 / 0
    I'm wondering too.... I also like getting crazy on the sky with my furious. So far I found it very difficult after 3th battery running In maximum speed may mysteriously looses control and falls (maybe the higher temperature of electronic) . I'm not using any fpv video and flying increases in time about 7min . TX transmitter must be taken off the drone. Battery capacity 2600mah .
     
    Last edited: Jun 21, 2017

Share This Page