F210 3D rebuild issue

Discussion in 'Walkera F210 3D' started by QuadKid, Apr 27, 2017.

  1. QuadKid
    Offline

    QuadKid Member

    Joined:
    Jan 12, 2017
    Messages:
    32
    Likes Received:
    1
    Trophy Points:
    8
    Location:
    Florida
    Ratings:
    +1 / 0
    Recently completely rebuilt an older F210 3D, new main board (f210), power board (f210), motors, VTX & RX, no OSD installed the only thing I didn't change were the ESC,s they seemed to be fine at the time. Using F210 parts combined with f210 3D ESC,s.
    Put it all together got it bound with the DEVO 7, have no throttle at 0 - 60% then it throttles to full power on the front 2 motors, no spin on the rear motors and I have to unplug the battery to get them to stop.

    I have not upgraded firmware in either Devo 7 or the F210 since I just got my UPO2 cables yesterday.

    Anyone have any suggestions, kinda at a loss as to where to go from here, everything has been replaced with Standard F210 electronics except the ESC's ( original F210 3D ESC )

    Any help appreciated, Thanks

     
  2. bjr981s
    Offline

    bjr981s Moderator Staff Member

    Top Poster Of Month

    Joined:
    Sep 19, 2015
    Messages:
    5,320
    Likes Received:
    334
    Trophy Points:
    83
    Location:
    Sydney, Australia
    Ratings:
    +436 / 14
    read my post to you on Devo 7 model reset to heli mode issues.
     

Share This Page