ESC Calibration

Discussion in 'Walkera Furious 320' started by oldking80, Nov 13, 2017.

  1. oldking80
    Offline

    oldking80 Member

    Joined:
    Sep 30, 2016
    Messages:
    105
    Likes Received:
    4
    Trophy Points:
    18
    Location:
    Italy
    Ratings:
    +5 / 0
    Does anyone know how to start the ESC calibration? Can you do that?

     
  2. bjr981s
    Offline

    bjr981s Moderator Staff Member

    Top Poster Of Month

    Joined:
    Sep 19, 2015
    Messages:
    5,034
    Likes Received:
    311
    Trophy Points:
    83
    Location:
    Sydney, Australia
    Ratings:
    +405 / 13
    Are you using a non Walkera RX and TX?

    That is the only reason to do an ESC calibration.
     
  3. oldking80
    Offline

    oldking80 Member

    Joined:
    Sep 30, 2016
    Messages:
    105
    Likes Received:
    4
    Trophy Points:
    18
    Location:
    Italy
    Ratings:
    +5 / 0
    No, I use deviation tx and Walkera Rx. I wanted to calibrate because one engine runs less than the other
     
  4. bjr981s
    Offline

    bjr981s Moderator Staff Member

    Top Poster Of Month

    Joined:
    Sep 19, 2015
    Messages:
    5,034
    Likes Received:
    311
    Trophy Points:
    83
    Location:
    Sydney, Australia
    Ratings:
    +405 / 13
    When does it run less than the others?

    That is normal. The props all operate at different speeds depending on what is required to stabilise.

    If you have a slow motor throughout the entire rev range then you need to check that it is OK.

    When did this start? Has this motor been replaced? Is it the same model as the other motors.
     
  5. oldking80
    Offline

    oldking80 Member

    Joined:
    Sep 30, 2016
    Messages:
    105
    Likes Received:
    4
    Trophy Points:
    18
    Location:
    Italy
    Ratings:
    +5 / 0
    All engines and esc are originals and equals. When I run min throttle, an engine turns less. And in flight does not remain stable but always tries to level
     
  6. bjr981s
    Offline

    bjr981s Moderator Staff Member

    Top Poster Of Month

    Joined:
    Sep 19, 2015
    Messages:
    5,034
    Likes Received:
    311
    Trophy Points:
    83
    Location:
    Sydney, Australia
    Ratings:
    +405 / 13
    Calibration will do nothing.

    Have you changed any settings on this model?

    If you have you have broken something.
     

Share This Page