Broblem with new powerboard

Discussion in 'Walkera Rodeo 150' started by Stathis, Jul 4, 2018.

  1. Stathis
    Offline

    Stathis New Member

    Joined:
    May 24, 2018
    Messages:
    3
    Likes Received:
    0
    Trophy Points:
    1
    Ratings:
    +0 / 0
    Hello to all.
    I bought a rodeo 150 few months ago and after few flights later will begin some problems with the batteries. After 2 minutes of flight the drone biping that the battery is over! When I measure the battery shows that it was 60%.That happens with all the batteries including the original one. After all I decide to change the powerboard with a new one. After that (with new powerboard) I have problem with the connection! The devo 7 binds with the drone(red light stays on) but when I throttling the motors doesn't respond at all! I didn't change anything in devo 7, I flight an f210 with the same transmitter and it flies well. Do you recommend anything to start the motors?
    Thanks anyway.

     
  2. bjr981s
    Offline

    bjr981s Moderator Staff Member

    Top Poster Of Month

    Joined:
    Sep 19, 2015
    Messages:
    5,208
    Likes Received:
    318
    Trophy Points:
    83
    Location:
    Sydney, Australia
    Ratings:
    +415 / 13
    You need to check the connections on the power board. The FC connector or RX is not connected correctly.
     

Share This Page