Binding to controller just beeping

Discussion in 'Walkera Aibao' started by jwwgold, Mar 29, 2018.

  1. jwwgold
    Offline

    jwwgold New Member

    Joined:
    Mar 29, 2018
    Messages:
    1
    Likes Received:
    0
    Trophy Points:
    1
    Ratings:
    +0 / 0
    I have held the power button down then switched on the drone right away and still nothing but beeping. I can connect my S8+ to the controller and it says I cannot connect to the drone but I do see status changes for modes and battery life of controller etc and some areas for configuration using Walkera Drone App. What are the QR codes on the bottom of the controller and the drone used for? Is there another way for me to try to get them to communicate. I did the firmware update to the drone. Is there something to update the controller? Is there some default settings on the router in the controller? I went into the address 192.168.1.2 and looked around and I want to make sure all is well there. Can someone tell me what those settings should be?

    Thanks!

     
  2. bjr981s
    Offline

    bjr981s Moderator Staff Member

    Top Poster Of Month

    Joined:
    Sep 19, 2015
    Messages:
    5,208
    Likes Received:
    318
    Trophy Points:
    83
    Location:
    Sydney, Australia
    Ratings:
    +415 / 13
    I take it that this all went south after you did the FW upgrade?
     

Share This Page