Betaflight 3.1.6 flashed spracingf3 fw cant arm motors

Discussion in 'Walkera F210 Advanced / Modding Forum' started by jbannister756, Mar 23, 2017.

  1. jbannister756
    Offline

    jbannister756 New Member

    Joined:
    Mar 22, 2017
    Messages:
    5
    Likes Received:
    0
    Trophy Points:
    1
    Ratings:
    +0 / 1
    So i used the Betaflight 3.1.6 configurator to flash spracingf3 fw on my f210. Betaflight is communicating with the FC just fine however I can not see to set an arm switch in the modes section. I have arm set to Aux 3 however it does not actually arm the motors. Has anyone experienced this problem?

     
  2. jbannister756
    Offline

    jbannister756 New Member

    Joined:
    Mar 22, 2017
    Messages:
    5
    Likes Received:
    0
    Trophy Points:
    1
    Ratings:
    +0 / 1
    Figured out the arming problem. For those with the same problem, the new versions of spracingf3 have throttle min default of 1040. The motors wont arm if the throttle is not below 1040. You need to adust your throttle range on Devo 7 and it will all the motors to arm.
     
  3. Lukezen27
    Offline

    Lukezen27 Active Member

    Joined:
    May 6, 2016
    Messages:
    215
    Likes Received:
    33
    Trophy Points:
    28
    Location:
    Sydney, Australia
    Ratings:
    +47 / 0

Share This Page