10 second flights

Discussion in 'Walkera TALI H500' started by LaRidah, Feb 16, 2019.

  1. LaRidah
    Offline

    LaRidah New Member

    Joined:
    Feb 16, 2019
    Messages:
    4
    Likes Received:
    0
    Trophy Points:
    1
    Ratings:
    +0 / 0
    I have flown the 500 over 30 times with only 1 small mishap, it worked fine after that for about 5 more flights, i didnt fly it for about 6 months and now after it finally binds by turning the radio on, turning the 500 on, turning the radio off and the back on again, once i get good a good gps signal, unlock the motors, manually take off and after 10 seconds the radio starts to buzz and the 500 loses power and start coming down, good thing i always test it in my living room.

    From some of the previous threads i have read doesnt look like there is any support on the $1000 paper weight, if somebody happens to know of the solution you help would greatly appreciated.


    Thnks

     
  2. conner
    Offline

    conner Member

    Joined:
    Aug 28, 2016
    Messages:
    36
    Likes Received:
    3
    Trophy Points:
    8
    Location:
    virginia, usa
    Ratings:
    +3 / 0
    could it be the voltage failsafe that is programmed into the radio? how many led bars are on the battery sensor when it cuts off? I uploaded a manual which says something in secion 4.7 "sensor setting"
     

    Attached Files:

  3. bjr981s
    Offline

    bjr981s Moderator Staff Member

    Top Poster Of Month

    Joined:
    Sep 19, 2015
    Messages:
    5,512
    Likes Received:
    378
    Trophy Points:
    83
    Location:
    Sydney, Australia
    Ratings:
    +481 / 14
    What was the battery charge status when you stored the battery?

    If it was full or discharged the battery is now toast.

    Batteries need to be charged / discharged to 3.8V per cell if left in storage.
     

Share This Page