The flight packs for the DJI Digital FPV are smaller than the Occusync ones so will fit a 210 very well. The controller should work fine. I bought...
Then that would be a 1S LiPo. Can you take a picture?
How do you know that the bind process completes successfully? If it is binding and beeping then its possible the battery is flat.
hmm. That is too small for a 6S 1800mah. Can you confirm the connectors on the Battery? It should have 1 lead with 2 thick wires Red and Black...
It's not clear what you actually reset. There is a pin hole in the RX I assume that you reset that. To reset you need to hold the button down and...
Did you have a heavy landing? If you did it is most likely the ribbon connectors for the FC and RX. Disassemble and clean the connectors and check...
I would think that it would most likely be a 6S 1800. Can you measure the physical dimensions for me. Then I would have a better guess. Cheers
Hi Paul, It is a very old Walkera when they were known as dragonfly. I don't know the specifics of this particular helicopter. Cheers Brian
Go to Profile settings
El ajuste PID se realiza dentro de Cleanflight. Debe conectar su dron a la PC, ejecutar Cleanflight y ajustar la configuración PID. Pero asegúrese...
Good Post. I have made it a Sticky.
You said you had an advance Did you mean a pro? On the Pro if you don't take off within about 3 seconds the motors will disarm again. You have to...
Male sure that you clear any Fixed ID setting in the TX and the RX.
Sí, si obtienes un Walkera Devention RX, puedes usarlo en cualquier dron que tenga su propio controlador de vuelo.
The trims are the buttons one for each stick axis. Make sure that ghee say 0 on the TX display. The beep when pushed side to side.
Separate names with a comma.
